Cedar Park is full of homes built in the late 90s and 2000s, and a lot of them went up with builder-grade masonite, hardboard, or early vinyl on the elevations the street doesn't see. Twenty-odd years of Texas sun later, that siding is chalking, swelling at the bottom edge, or quietly letting water into the sheathing behind it. Replacing it is most of the siding work we do in Cedar Park.
Installation, replacement, or repair?
Three different jobs get called siding installation in Cedar Park, and they price nowhere near each other, so it is worth knowing which one you are asking about before you collect quotes.
New installation is siding going onto bare sheathing: an addition, a rebuilt wall, a converted garage, a new screened porch or sunroom that needs its exterior finished. There is no tear-off, no disposal, and no unpleasant surprise waiting behind the old material, so it is the cleanest and cheapest of the three per square foot.
Replacement is the bulk of what we do here. The old hardboard, masonite or vinyl comes off, the sheathing gets inspected and repaired, the house gets re-wrapped, and new fiber cement goes on. Most of the cost difference against a new install is tear-off, disposal and whatever the wall is hiding.
Repair is a section, a course, or a corner. Sprinkler damage at the bottom of one wall. A hail strike on the west elevation. A woodpecker. If the rest of the house is sound, a repair is genuinely the right answer, and we will say so even though it is the smallest invoice on the list.
Siding work we do in Cedar Park
- James Hardie fiber cement siding. The default recommendation for this climate and the large majority of what we install. Lap siding, panels, and board-and-batten.
- Full siding replacement. Tear off the old material, inspect and repair the sheathing, re-wrap, then install new. The only honest way to deal with hardboard that has started to fail.
- Partial replacement and repair. When only one elevation has gone, usually the west or south face that takes the sun, or a section damaged by hail.
- Trim, fascia, and soffit. Often more rotted than the siding itself, and the place where water has usually been getting in.
- Storm and hail damage. Free inspection, and we work directly with your adjuster.
- Colour changes. Factory-finished ColorPlus, or primed Hardie painted on site if you want a custom colour.
Why fiber cement, specifically here
Central Texas is unusually hard on exterior cladding. Long stretches of direct UV, wild swings in humidity, hail most springs, and a termite population that takes wood seriously. Fiber cement is the material that handles all four at once.
- It does not rot or swell. The failure mode of hardboard and masonite here is water wicking into the bottom edge. Fiber cement has no organic material to absorb it.
- Termites have no interest in it. Meaningful in Williamson County.
- It holds paint far longer. Factory-finished boards routinely go 15 years between repaints, against 5 to 7 for wood siding in this sun.
- It handles hail far better than vinyl, which cracks, or aluminium, which dents permanently.
- Insurers and buyers both recognise it. It reads as a genuine upgrade at resale, not a repair.
For the full material-by-material cost comparison, see our 2026 Hardie siding cost guide for Austin. If the damage looks localised, our siding repair cost guide covers repair pricing and when a patch is genuinely the right call.
Siding materials we install, and what we will talk you out of
We are not locked to one manufacturer. What follows is how the common options behave on a Cedar Park house, not how the brochures describe them.
| Material | Installed, per sq ft | How it does here |
|---|---|---|
| James Hardie fiber cement | $10 to $16 | What we install on most jobs. Will not rot, ignores termites, takes hail, holds paint 15 years plus. |
| LP SmartSide engineered wood | $8 to $13 | Lighter, faster, real product. Still wood based, so grade clearance and cut-end sealing have to be right. |
| Board-and-batten fiber cement | $12 to $18 | Gables, entry walls, modern farmhouse elevations. More trim labour than lap. |
| Vinyl siding | $5 to $9 | Cheapest quote you will get and the one we steer people off. Hail cracks it and sustained heat can distort it. |
| Stucco repair and patch | Quoted per job | We repair and tie into existing stucco. Full stucco systems we sub out rather than pretend. |
| Trim, fascia and soffit | $9 to $16 / linear ft | Rarely the headline and frequently where the water was getting in. |
Ranges are Cedar Park installed pricing for 2026, including tear-off where applicable, house wrap, flashing, trim and finish.
What siding costs in Cedar Park
Siding is priced by the square foot of wall area, not by the floor area of the house, which is why two 2,400-square-foot homes can quote very differently depending on how many storeys and how much trim they have.
| Scope | Typical range | Notes |
|---|---|---|
| Hardie lap siding, installed | $10 to $16 / sq ft | Tear-off, wrap, install, trim, paint |
| Single elevation replacement | $6,000 to $14,000 | Most common Cedar Park job |
| Full re-side, 1,500 sq ft single storey | $17,000 to $26,000 | $26,000 to $36,000 if complex |
| Full re-side, 2,000 sq ft single storey | $22,000 to $34,000 | $34,000 to $46,000 if complex |
| Full re-side, 2,500 sq ft two storey | $30,000 to $44,000 | Access and staging add cost |
Rotted sheathing found under the old siding is the usual variable. We quote the repair rate up front so it is not a surprise mid-job.
What the job actually involves
- Free on-site inspection. John walks every elevation, checks the bottom courses and the trim, and looks for the soft spots that tell you where water has been getting in.
- Line-itemed quote. Material, tear-off, disposal, sheathing repair rate, trim, and paint, all separated so you can see what you are paying for.
- HOA submission. Most Cedar Park subdivisions review exterior colour changes. We prepare the packet.
- Tear-off and inspection. The old material comes off and we find out what the sheathing underneath looks like. This is the step where honest contractors and cheap ones separate.
- Weather barrier. New house wrap and flashing at every window and door. The part you will never see and the part that determines whether this lasts.
- Install, trim, caulk, paint. Correct fastener spacing, proper clearance at grade and at the roofline, and the joint detailing that keeps water out.
- Cleanup and walkthrough. We magnet-sweep for fasteners and walk every elevation with you.
Most Cedar Park re-sides run one to three weeks depending on size and how much sheathing needs replacing.
Signs your Cedar Park siding is finished
Homeowners usually call us about the one wall that looks bad. Half the time the wall that looks worst is not the wall with the problem. Things worth walking out and checking yourself, ideally on a sunny morning when shadows show texture:
- Swelling or crumbling at the bottom course. Especially anywhere a sprinkler head reaches. On hardboard this is the classic Cedar Park failure and it means water has been sitting there for years.
- Chalk on your hand. Run a palm down a sunny elevation. A white film is the paint binder giving up, which is a repaint at best and past saving at worst.
- Soft spots. Press firmly around windows and at the corners. Anything that gives is wet behind the surface.
- Gaps at the butt joints. Boards that have shrunk apart are letting water directly onto the wrap, and the wrap is twenty years old too.
- Paint failing again within two or three years. Paint does not fail that fast in isolation. It fails that fast because the substrate is holding moisture.
- Interior clues. A stain in the top corner of a bedroom, or an outlet on an exterior wall that smells musty, usually starts outside.
- Dimpling or cracking after a hail spring. Vinyl cracks outright. Hardboard bruises. Both are claimable and both have deadlines.
Permits, HOA review, and Cedar Park specifics
A straight like-for-like re-side in Cedar Park generally does not need a building permit. The moment structural sheathing is replaced, an opening is altered, or the work is part of an addition, it does, and it is pulled through the City of Cedar Park. Homes just outside the city limits fall under Williamson County instead, which is a different counter and a different timeline. We sort out which one you are in before we quote, because getting that wrong is how a two-week job becomes a two-month job.
HOA architectural review is the part that delays people here. Buttercup Creek, Twin Creeks, Ranch at Brushy Creek and Block House Creek all review exterior colour changes, and several maintain approved palettes you have to choose from. Review commonly takes two to four weeks. We prepare and submit the packet, including colour samples and elevation photos, and we start it the day you sign rather than the week before we are due on site.
Things worth knowing before you get quotes
Ask what happens when they find rot
On a house with twenty-year-old hardboard, some bad sheathing is likely. A quote that says nothing about it either has not thought about it or is planning to renegotiate once the walls are open. Get the repair rate in writing before you sign.
Clearance at grade matters
Fiber cement needs a specified gap between the bottom course and the ground or a hard surface. Installed tight to the dirt it will wick moisture, and it will also void the manufacturer warranty. It is one of the most common installation faults we see on re-sides done cheaply.
Factory finish versus site paint
ColorPlus arrives finished, has a long finish warranty, and only needs touch-up at the cut ends. Site painting gives you any colour you like and costs less up front, but you are relying on the paint job rather than a factory coating. Both are legitimate. Know which one you are being quoted.
If it is hail, involve your insurer first
Cedar Park takes hail most springs, and siding damage is frequently covered alongside the roof. Do not let anyone start work before the adjuster has seen it. We do free inspections and meet the adjuster on site.
Cedar Park neighborhoods we serve
We install and replace siding across Buttercup Creek, Twin Creeks, Anderson Mill, Cypress Creek, Carriage Hills, Reagan’s Overlook, Block House Creek, Brushy Creek, Forest Oaks, and Ranch at Brushy Creek, plus the rest of northwest Travis and Williamson counties.
Not sure whether you need a repair or a re-side? That is exactly what a free inspection is for. John will tell you if one elevation will get you another ten years.
Book my free inspectionWhy Cedar Park homeowners pick us
- We open the wall before we promise anything. Sheathing repair rates quoted up front, not invented mid-job.
- HOA submissions handled. Including colour approval, which Cedar Park subdivisions do check.
- We work your insurance claim with you on hail and storm damage, and meet the adjuster on site.
- Daily progress photos by text. You always know where the job stands.
- 5.0 stars on Google. Read the reviews from your neighbors.
Also looking at the backyard? See deck builders in Cedar Park or patio covers in Cedar Park.
Need more than siding in Cedar Park? See everything we build in town on our Cedar Park contractor page, or read about our siding work across greater Austin.
Ready for a free siding quote in Cedar Park? Call or text (512) 587-3914, or send a few photos of the worst elevation and John will tell you what he sees.
Get my free siding quoteCedar Park siding installation questions, answered
How much does siding cost in Cedar Park, TX?
James Hardie fiber cement siding in Cedar Park typically runs $10 to $16 per square foot installed, including tear-off, house wrap, trim, and paint. A single elevation usually lands between $6,000 and $14,000. A full re-side runs about $17,000 to $26,000 on a 1,500-square-foot single storey, $22,000 to $34,000 at 2,000 square feet, and $30,000 to $44,000 on a 2,500-square-foot two storey. Rotted sheathing discovered during tear-off is the main variable, so we quote that repair rate up front.
Do I need to replace all my siding or just part of it?
Often just part. On a lot of Cedar Park homes only the west and south elevations have really failed, because those take the sun. If the rest is sound, replacing one or two elevations can buy you another decade for a fraction of the cost. The catch is matching, so if you are changing colour anyway a full re-side often makes more sense. We will tell you which situation you are in at the inspection.
How long does a siding job take in Cedar Park?
Most Cedar Park re-sides run one to three weeks on site, depending on the size of the house and how much sheathing has to be replaced once the old material comes off. Single-elevation jobs are usually under a week. HOA colour approval can add time before we start, so it is worth submitting early.
Will my insurance cover storm-damaged siding?
Frequently, yes. Cedar Park gets hail most springs, and siding damage is often covered alongside roof damage on the same claim. Do not have any work started before your adjuster has inspected it. We do free damage inspections, document what we find, and meet the adjuster at the house.
Is Hardie siding worth it over vinyl in Central Texas?
In this climate, we think so. Vinyl cracks under hail and can distort in sustained heat, and neither is unusual here. Fiber cement will not rot, does not interest termites, holds paint far longer under our UV, and handles hail much better. It costs more up front and it is the material we would put on our own house in Williamson County.
Do you handle Cedar Park HOA approval for a colour change?
Yes. Most Cedar Park subdivisions require architectural review for exterior colour changes, and several maintain an approved palette. We prepare and submit the packet as part of the project, including colour samples where the HOA wants them.
Who does siding installation in Cedar Park, TX?
JB Contracting ATX installs siding throughout Cedar Park and the surrounding Williamson County communities, including Buttercup Creek, Twin Creeks, Block House Creek, Brushy Creek and Anderson Mill. We are family owned, licensed and insured, and rated 5.0 on Google. Owner John Bernard walks every estimate himself, so the person pricing your job is the person responsible for it.
Do you install siding on new construction and additions?
Yes. New installation onto bare sheathing is a straightforward job and it prices better per square foot than a replacement, because there is no tear-off, no disposal, and nothing hidden behind the old material. We regularly finish additions, rebuilt walls, converted garages, and the exteriors of new screened porches and sunrooms in Cedar Park.
Can you install new siding over the existing siding?
It can be done and we do not recommend it. Going over the old material hides the exact thing the inspection is meant to find, which is whether the sheathing underneath is wet or rotted. It also adds thickness that throws off window and door trim depth. On a Cedar Park home with twenty-year-old hardboard, there is usually something back there worth knowing about.
What is the best siding for a Cedar Park home?
Fiber cement, in nearly every case. Cedar Park gives cladding long stretches of direct UV, hail most springs, big humidity swings and an active termite population, and fiber cement is the one common material that handles all four. LP SmartSide engineered wood is a legitimate second choice at a lower price. Vinyl is the cheapest quote you will receive and the one we talk homeowners out of.
How soon can you start a siding installation in Cedar Park?
Usually within two to four weeks for the work itself. The realistic gating item is HOA architectural review if you are changing colour, which commonly runs two to four weeks on its own, so we submit that packet the day you sign. Storm and hail jobs we move on faster, because insurance claims have deadlines.
Deciding between fiber cement and engineered wood? Read our side-by-side comparison of Hardie vs LP SmartSide siding for Austin homes.
